Chrysler Voyager 2.4L Repair Information

Chrysler Voyager 2.4L Rear End Repair Information

Here you can find information regarding repairs to the Chrysler Voyager rear end system. These repairs include the rear control arms installation, the rear swaybar information and bolt torque specs, the rear diff fluid change procedures, and the rear end watts system installation. All of these repairs and procedures include in depth details on how to perform the replacement and or repair. They also contain all the detailed torque specs needed for each bolt involved in the repair.

Rear Wheel Hub Torque Specs

The Voyager rear wheel hub is held to the vehicle much like the front wheel hubs. There are 4 bolts which torque into nuts that hold the hub onto the rear wheel suspension. To remove these bolts and the hub assembly you will first need to jack up the vehicle and remove the braking system from the corresponding side of the vehicle. Once out of the way you can remove the bolts by using the access holes on the hub plate itself. Be sure to hold the nuts on the other end with a wrench. Once all 4 have been removed you can then remove the rear hub assembly and place a new part into its place. The 4 bolts can be torqued down to 41 ft-lbs.

Chrysler Voyager Rear Wheel Hub Torque Specs : 41 ft-lbs

 

Rear Shocks Installation

To replace the rear shocks on a Chrysler Voyager you will need to remove two sets of bolts/nuts located at the bottom and top of the shock. Both of these fasteners can be accessed from underneath the vehicle by jacking it up and removing the wheel. To uninstall the old shock simply just remove both of the fasteners sets and the part will come out. When installing the new part reverse the procedure and tighten up the lower bolt to 55 ft-lbs and then the upper bolt to 55 ft-lbs.

Chrysler Voyager Rear Shock Upper Bolts Torque Specs : 55 ft-lbs

Chrysler Voyager Rear Shock Lower Bolt Torque Specs : 55 ft-lbs